ALWAYS READ THE LABEL AND FOLLOW THE DIRECTIONS FOR USE.Description Excilor® ULTRA delivers complete penetration for up to 24 hours.
Excilor® ULTRA has an immediate brightening and smoothing effect and is compatible with nail varnish. The old layer can be peeled-off within seconds.
The nail grows back healthier and stronger so re-contamination has being prevented.
Size: 30mL
Warnings For external use only. Do not use if you have a known hypersensitivity or allergy to any of the ingredients. Apply on nail only, avoid contact with surrounding skin. Avoid all contact with eyes and mucous membranes. If the product comes into contact with eyes or mucous membranes, rinse thoroughly with water. No clinical data are available on use of the product by children, or by pregnant or breastfeeding women. Diabetics with foot problems should consult their doctor when starting to use Excilor® ULTRA. Do not use the product after its expiry date.
Always read the label. Follow the instructions for use. If symptoms persist, talk to your health professional.
Caution
Always read the label. Follow the instructions for use. If symptoms persist, talk to your health professional.
Ingredients Water, polyurethane, acetic acid, peppermint oil, octyl gallate, polysorbate 80, dehydroacetic acid, cetyl acetate, acetylated lanolin alcohols, preservatives.
Active Ingredients: Water, polyurethane, acetic acid, peppermint oil, octyl gallate, polysorbate 80, dehydroacetic acid, cetyl acetate, acetylated lanolin alcohols, preservatives.
Direction Excilor® ULTRA must be applied once a day preferably after showering. Before application clean
the nail and remove any old layers of nail varnish.
Next, use the brush to coat the whole of the surface of the nail. Make sure to apply a sufficient layer of
Excilor® ULTRA. The contents of the bottle may contain clots of dried film residue. This is completely
normal and is caused through contact with the air. This will have no influence on product efficacy.
Allow the nail to dry. This takes between 3 to 5 minutes.The product is white when applied but as it dries
it becomes transparent and you will notice a rubber coating which will decrease with time. For optimal effect it is advisable to wait for up to 5 minutes before putting on socks and/or shoes. After application, a
tingling sensation under the nail is normal and indicates that the product is penetrating the nail.
The formed coating is water-resistant and withstands normal wear and friction. The coating may chip
off at the edges of the nail but this does not affect product efficacy. The film layer is compatible with nail
varnish and when dried nail varnish can be applied.
After 24h, remove the film. You can do this by peeling off the coating at the edge or side of the nail.
Gently roll off until the complete coating is released from the nail. You may find this easier by using
warm water. Apply new product, as instructed above. Wash your hands well after each removal and
subsequent application. For best results, treat the complete nail for a minimum of three months and
continue the course of treatment until the nail has recovered completely.
Make sure that the bottle is fully closed after each treatment to prevent evaporation. At the border of
the glass film formation may occur.
Clean the nail and, if wearing nail polish, remove completely before using Excilor® ULTRA. Use the brush to coat the whole nail. Make sure you apply Excilor® ULTRA generously. Allow the nail to dry (3 to 5 minutes) before putting on socks and/or shoes. After 24 hours, remove the film. This is easily done by starting to peel off the film at the side of the nail. Continue to rub off until the complete film is released from the nail.
Storage Instructions
Please store at room temperature (15-25°C) and avoid exposure to direct sunlight
Storage Temperature: Store between 15-25°C
